This is an 'approximate' list of service items for your MINI.  The list may not be complete as service items may have been added by the factory since this list was created.  Some dealers may perform fewer or more items than this list.  This list is only a 'guide' and is not an 'up-to-date' official factory list.

Inspection I and Inspection II are performed at alternate oil service intervals.  If the first service is an Oil Service and Inspection I, then the next service will be Oil Service and Inspection II, then back to Oil and Inspection I.  Inspection II includes most of the tasks from Instpection I with additional Inspection II tasks. 

OIL SERVICE:

Oil and Filter
Reset service interval display
Interior Cabin Filter
Check brake pads
Check brake rotors
Clean brake pad contact points
Grease wheel centering hubs
Check parking brake


INSPECTION I:

Oil and Filter
Check Trasmission Fluid for leaks
Change CVT (automatic transmission) fluid
Check CV joint boots for damage or leaks
Visually check fuel tank, fuel lines and connections for leaks
Check condition, position and mounting of exhaust system.  Adjust if necessary.
Check struts and shock absorbers for leaks
Check front control arm bushings for damage or wear
Check power steering system for leaks.  Check fluid level and add if necessary.
Check steering rack and tie rods for tightness.  Check condition of steering linkage and steering shaft joints.
Check overall thickness of front and rear brake pads.  If replacement is necessary:
  - Examine grake disc surface 
  - Clean brake pad contact points in calipers 
  - Grease wheel centering hubs 
  - Check thickness of parking brake linings only when replacing rear brake pads 
  - Check operation of parking brake and adjust as necessary
Check brake system connections and lines for leaks, damage and incorrect positioning
Check parking brake actuator.  Adjust if necessary.
Check all tire pressures (including spare if equipped) and correct if necessary.
Check condition of tire tread surface, tread wear pattern.  Align if necessary.
Inspect entire body according to terms of rust perforation limited warranty. (Must be performed every 2 years)

Read out on-board diagnostic (OBDII) fault codes
Check engine coolant system / heater hose connections for leaks.
Check coolant level and antifreeze protection level.  Add if necessary
Check windshield washer fluid level and antifreeze protection.  Add if necessary.
Check air conditioner for operation.
Replace ventilation mircofilter. (Reduce replacement interval in dusty conditions.)
Reset service interval display.

Check battery state of charge
Check operation of: 
  - headlights, foglights, parking lights, back-up lights, turn signals, 
  - emergency flashers, stop lights, license plate lights, interior lights, 
  - glove compartment light, make-up mirror light, flashlight, 
  - engine compartment light, trunk light.
Check instrument panel lights
Check warning and indicator lights, check control
Check operation of horn, headlight dimmer and flasher switch
Check wipers and windshield washer system
Check aim of washer jets and adjust if necessary
Visually examine all airbag units for torn covers, obvious damage or attachment of decals, decorations, or accessories
Check central locking system
Check operation and condition of door, engine hood and rear hatch latches
Check heater, air-conditioner blower and rear defogger operation
Check operation of rear view mirrors

Check braking performance, steering, heating and air-conditioner operation
Check manual transmission and clutch or automatic transmission operation

INSPECTION II:

Air filter Element
Serpentine Belt - 60,000 miles for Cooper S
Brake Fluid - Every 2 years (dealer recommended)
Coolant - Every 4 years
Oxygen Sensor - Replace at 100,000 miles
Spark Plugs - Replace at 100,000 miles

Article Date: Apr 20, 2009
Car Accociations: JAGUAR
Hits: 421